Product Details
Jemmco's Premium JemmTrac™ 810 Smooth Traction Tape features an acrylic adhesive, which helps to eliminate oozing that's typical with a silicone adhesive.
This smooth, uncoated Traction Tape has an optimized release surface to prevent building up of adhesives, inks and coatings on rollers or drums. Additionally, the tape works to minimize wrinkles during production when wrapped in spirals onto drums and rollers.
Features
- High adhesion guarantees a safe bonding to rollers or drums
- Temperature, media and moisture resistant adhesive
- Acrylic adhesive eliminates oozing and sticky clean-up
- Flexible and abrasion resistant
Technical Specifications
| Release Properties |
Good |
| Traction Properties |
Very Good |
| Heat Resistance |
-40°C to 125°C |
| Wear Resistance |
Good |
| Hardness |
N/A |
| Adhesive Type |
Acrylic |
| Surface Finish |
Smooth |
| Wall Thickness |
0.55 mm |
| Available Widths |
2.0" |
| Available Lengths |
6 meters |
| Liner |
No |
| FDA Compliant |
No |
Installation
Four Simple Steps for In-Plant Tape Installation!
- 1.
To get started, wrap your Jemmco tape one full rotation around the roller at the angle required to achieve your spiral. Make a mark on the second wrap where it meets the beginning of the tape.
- 2.
Lay the tape on a flat cutting surface and cut the tape at an angle from the marked point to the opposite corner of the beginning of the tape roll.
- 3.
If applicable, remove the liner at the start point and begin wrapping the tape at the edge of the roller.
- 4.
Wrap the tape around the roller - at even angles - without leaving any gaps or air underneath the tape.
